| FLOUNDER LIGHT |
| AquaStar FLOUNDER LIGHT |
| DESIGN YOUR OWN |
Total dimensions are 50" tall and 60" wide. (4) 100-watt AquaStar White lights are used.
The end pieces with the lights are 18". The middle joints are 8".
The PVC coming out of the T bracket holding a light is 11".
List of items to build this:
All 1.25" schedule 40 PVC
50" for the shaft
2 @ 18" for the end lights
2 @ 11" for the middle lights
2 @ 8" for the middle joints
3 T brackets
The light is held in place by using a bow mount trolling motor bracket (Minn Kota in my case), minus
the trolling motor itself. Add a little bit of duct tape to keep it from sliding as the trolling motor
bracket and PVC isn't a prefect fit.
The end pieces with the lights are 18". The middle joints are 8".
The PVC coming out of the T bracket holding a light is 11".
List of items to build this:
All 1.25" schedule 40 PVC
50" for the shaft
2 @ 18" for the end lights
2 @ 11" for the middle lights
2 @ 8" for the middle joints
3 T brackets
The light is held in place by using a bow mount trolling motor bracket (Minn Kota in my case), minus
the trolling motor itself. Add a little bit of duct tape to keep it from sliding as the trolling motor
bracket and PVC isn't a prefect fit.
| This Founder rig was built by Dale Tyre from Bainbridge Ga. Thanks to Dale for supplying us with the photo's and design. |
| $10-$20 Value |
| An Underwater Fishing Light Company |
| Notice These fishing lights use halogen bulbs and must be submerged in water to use. |
| Fishing Lights Etc. 201 W. 23rd. St. Hays, KS 67601 Copyright © 2003-2008 All rights Reserved. |
     |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |